SY1DAL wrote: ↑Wed Oct 20, 2021 4:46 pm
I get this message now when i click on CONFIG menu "(re)get QRZ key .
This is a normal message and means that you successfuly get the key to querry the database.
When i type the callsign - in this example yours, i get info, but the frequency was not displayed immediately.
It took some seconds delay (approx. 30sec) before it got displayed (in our example 7.16Mhz) .
The frequency is writtem when you tune the radio (same for mode), is not something you get from QRZ.
It takes until you change it.
Noticed also that in CONFIG menu, the option "extra info" is not saved. Once you quit the app. You have to go again there and enable that.
That menu item is no more used, I forgot to remove it. To get extra info you must click on the station picture. Anyway, I have doubts you can get extra info from QRZ without a paid subscription. A I can see, you get only Country.
Also as you can see in the screenshot, the MODE is again not displayed. You have to click with mouse to change it.
If you start call logging before connecting to the radio, both mode and frequency will be displayed. I will change in the next release to get it automatically if the radio is already on
And a weird thing is, that my radio was on frequency 7.16 (as per my example above) but when i close direct mode and re-open again, after i click on the CONNECT red button it displays frequency 7.130 instead. Why isn't it reading properly from the radio ?
You're sure you didn't touched the mouse wheel when pressing on connect? I've checked here and it stays on the same freq.
One other thing i noticed is the logging feature, each time i press L (shortcut) it ask me to save ADIF file. And i give a name and it says it will start with an empty adif file. After i save a QSO it asks me to save a new ADIF file that has my callsign in the filename instead of saving the first ADIF file i was asked. Perhaps i might have to demonstrate this with a video.
I think is a bug. Didn't fully tested all possible sequences.. Try to open an adif file (File open) and then close logging and start it again. You must not be asked anything from now on.
I also believe that the once you click on the SAVE button, in the logging feature, all fields must be cleared except for the frequency, unless you change frequency / band. Because now you have to press the CLEAR button in order to write the next callsign to save a new QSO.
Another bug for v4b13
One last thing i discovered is that when you have LOGGING enabled (by pressing L) if you close the window on the left (direct mode) the LOGGING window still stays ON and you have to press only X in the corner to close it.
Another bug for v4b13
73 Dan YO3GGX